ep

January 4, 2021

1.A connecting link of an O-ring Chain for standard application is pre-coated with grease in the pins. Just before connection, verify the grease within the surfaces of pins, and in case the volume of grease is compact, apply grease with bare hands. (If gloves are employed, the grease is going to be absorbed from the gloves.)
Example: Once the connecting link (I) of an O-ring chain for general application is
shipped, O-rings are fitted on the roots from the pins. In case the O-rings come loose because of vibration in the course of transport, refit the O-rings in to your roots in the pins.
In this instance, make sure you return the grease collected with the roots with the pins towards the central surfaces on the pins, more at portion A than at portions B proven during the above illustration. (Portions A is worn as a result of sliding with all the bushings.)
2.The chain is usually most easily linked within the teeth of the sprocket. Engage the links at each ends of the chain with the sprocket teeth and fit connecting pins. If the sprocket is often moved, the chain may also be linked over the loosened side.
three. Connecting process
one.Verify that O-rings are attached for the roots in the pins.
two.Should the volume of grease utilized around the connecting pins is modest, coat the pins with grease in the central portions.
3.Insert the connecting pins to the bushings with the inner links at the two ends.
four.Confirm that the grease is utilized to your whole face of your O-ring, and fit the O-ring onto the connecting pins.
5.Insert the connecting pins to the connecting plate and whilst pressing the connecting plate, set up the spring clip. Confirm no matter if the head (the end with no split) of your spring clip is turned from the feeding direction with the chain. (See the following illustration.)
six.Be sure to confirm that the spring clip is securely fitted inside the clip grooves with the connecting pins.
This completes jointing of the connecting link. Note that grease around the surfaces of connecting pins and O-rings could be eliminated through installation perform. In this instance, re-grease using the grease within the surface on the base chain or the grease in the polyethylene bag through which the connecting website link was contained.